Convo Inverter Cvf-s1 Manual Online

Convo Inverter Cvf-s1 Manual

Panel Control

: Allows start and stop operations directly from the unit's interface (Green for Start, Red for Stop). Terminal Control : Enables external control via terminals.

Tip:

For 4–20mA input, set jumper JP1 to “I” position and configure parameter F111 = 1. Convo Inverter Cvf-s1 Manual

Control Terminals

• Capacity: 800 VA — 2000 VA variants (assume one of these; check your exact model sticker)
• Input Voltage Range: 120–300 V AC (wide input for unstable grids)
• Output Voltage: 230 V AC ±1–2% (nominal; country-dependent)
• Output Waveform: Pure sine wave
• Frequency: 50 Hz / 60 Hz selectable or auto-detect
• Battery Type: Sealed lead-acid (SMF/VRLA) / Gel / Tubular battery compatible
• Battery Voltage: 12 V / 24 V (model-dependent)
• Charging Current: 10 A – 30 A selectable (higher-capacity models)
• Efficiency: 85%–95% (depending on load and model)
• Topology: MOSFET/IGBT-based inverter with microcontroller for control
• Transfer Time: <10 ms (fast transfer for minimal interruption)
• Protection Features: Overload, short-circuit, over-temperature, battery low/high voltage, reverse polarity protection
• Indicators & Display: LED indicators for power/battery/charging/fault; LCD or basic alphanumeric display on higher trims showing battery voltage, load %, charging current, mode
• Operating Temperature: 0–45°C (typical)
• Dimensions & Weight: Varies by capacity; compact wall/bench mountable chassis
• Noise Level: Low audible noise (fan-controlled on heavier loads)

Chapter 4: Troubleshooting Common Error Codes

For technical support, please contact our customer service team at [insert contact information]. Convo Inverter Cvf-s1 Manual Panel Control : Allows