Fanuc Series Oitf Plus Programming Manual !exclusive!
While typically a technical document, the FANUC Series 0i-TF Plus Programming Manual
- Tool Geometry (shape) vs. Tool Wear.
- Tool Nose Radius Compensation (G41/G42) for accurate profiling.
- Tip orientation (T-clamp logic) used in calculating tool paths.
Format:
G00 X(U)__ Z(W)__;
| G Code | Group | Function | Modal | |--------|-------|------------------------------------|-------| | G00 | 01 | Positioning (Rapid Traverse) | Yes | | G01 | 01 | Linear Interpolation (Feed) | Yes | | G02 | 01 | Circular Interpolation (CW) | Yes | | G03 | 01 | Circular Interpolation (CCW) | Yes | | G04 | 00 | Dwell (P or X/U address) | No | | G10 | 00 | Programmable Data Input | No | | G18 | 16 | Xp-Zp Plane Selection (Default) | Yes | | G20 | 06 | Inch Input Mode | Yes | | G21 | 06 | Metric Input Mode | Yes | | G32 | 01 | Thread Cutting | Yes | | G40 | 07 | Cutter Compensation Cancel | Yes | | G41 | 07 | Cutter Compensation Left | Yes | | G42 | 07 | Cutter Compensation Right | Yes | | G50 | 00 | Coordinate System Setting | No | | G70 | 00 | Finishing Cycle | No | | G71 | 00 | Stock Removal in Turning (Type I/II)| No | | G72 | 00 | Stock Removal in Facing | No | | G76 | 00 | Multiple Threading Cycle | No | | G83 | 09 | Deep Hole Peck Drilling (Z-axis) | No | | G96 | 13 | Constant Surface Speed Control ON | Yes | | G97 | 13 | Constant Surface Speed Control OFF | Yes | | G98 | 05 | Feed per Minute (mm/min) | Yes | | G99 | 05 | Feed per Revolution (mm/rev) | Yes | fanuc series oitf plus programming manual