Lnl3300m5 Installation Manual Upd Top: Lenel

Lenel LNL-3300-M5 is a Mercury-powered Intelligent System Controller (ISC) specifically designed to facilitate the migration of legacy CASI M5 or M3000 enclosures to the Lenel OnGuard system

Guide to Installing the Lenel LNL-3300-M5 Go to product viewer dialog for this item. Intelligent Controller The Lenel LNL-3300-M5 lenel lnl3300m5 installation manual upd top

Final Quick Reference Card (Save this section)

Step 3

: Turn DIP switch 1 to ON to enable the default login: Username : admin , Password : password . Note on Compatibility : All boards in a

Configure Networking

: Connect via the onboard 10/100 MB Ethernet port. Initial Configuration & IP Setup Location: Avoid high-EMI areas (motors

1. Check Lenel's official support/download portal (customer portal may require account).
2. Search for "LNL-3300M5 installation manual", "LNL-3300 M5 manual UPD", and "LNL-3300M5 topology" on vendor/reseller sites and technical PDF repositories.
3. If you have OnGuard software, check bundled documentation or firmware packages (UPD files).
4. Contact LenelS2 technical support or your Lenel distributor for the official UPD and TOP documents and firmware files.
5. If you need the wiring/firmware immediately, provide the device serial number and firmware version to support for precise instructions.

Note on Compatibility

: All boards in a single M5 or M3000 controller must be converted to Lenel M Series; you cannot mix legacy CASI M Series boards with Lenel M Series boards in the same enclosure. LNL-3300-M5

Remove the legacy CASI CPU and Power/Comm boards from the backplane.

1. Location: Avoid high-EMI areas (motors, transformers). Ambient temp: 32°F to 120°F (0°C to 49°C).
2. Surface: Use 4-6 screws into concrete or plywood backboard.
3. Grounding: Connect enclosure ground to facility earth ground. The M5 is static-sensitive.