Makerbase Mks Dlc V21 Manual Link May 2026

Makerbase MKS DLC v2.1

The is a high-performance control board designed for desktop CNC machines and laser engravers. It is widely recognized as a major upgrade over traditional 8-bit Arduino-based controllers due to its use of the ESP32 32-bit microcontroller , which provides integrated Wi-Fi, Bluetooth, and significantly faster processing speeds. Official Manual and Resource Links

1. Download Marlin from MarlinFW.org.
2. Open Configuration.h and set:

   #define MOTHERBOARD BOARD_MKS_DLC_V21
   

3. Refer to the manual’s Pin Map Appendix to assign any custom I/O (e.g., second Z-motor or filament sensor).

https://www.makerbase.com/download/MKS-DLC-V2.1-Manual.pdf makerbase mks dlc v21 manual link

Wiring Guide

: A visual guide is available via the MKS DLC32 V2.1 Pinout and Wiring Guide on Scribd . The Bridge Between Code and Craft: The MKS DLC v2.1 Makerbase MKS DLC v2

Software Configuration

: A visual pinout guide for stepper motors (X, Y1, Y2, Z) and auxiliary ports is available on Are you setting this up for a laser engraver CNC router , and do you need help with the specific GRBL configuration MKS DLC32 V2 Wiring Manual - Solo Motor Controllers Download Marlin from MarlinFW

🛠️ What is in the Manual / Repository?

• [ ] Verify board revision matches (page 2)
• [ ] Check 12V/24V jumper setting before powering on
• [ ] Review stepper motor current formula (Vref or UART current scaling)
• [ ] Compare Marlin pins file with manual’s pinout table
• [ ] Test thermistors and endstops via M119 before first hotend heating
• [ ] Keep a printed copy of the wiring diagram near your printer

The first step in setting up your MKS DLC V21 is to connect the hardware. This includes: