Rf Flasher Utility -

RF Flasher Utility

Flashing firmware carries a small risk of "bricking" the device—making it unresponsive. Follow these steps to ensure a successful flash:

GUI mode

BlueNRG-1 & BlueNRG-2:

Classic Bluetooth Low Energy (BLE) SoCs. rf flasher utility

🧪 Use Cases

The Scripting:

Integrating with ST-LINK or OpenOCD backends. Which area Data brief - STSW-BNRGFLASHER - The RF-Flasher utility RF Flasher Utility Flashing firmware carries a small

1. Software: Download SmartRF Studio 7 from TI’s website. Inside the installation folder (C:\Program Files\Texas Instruments\SmartRF Studio 7), locate rf-flasher.exe.
2. Hardware: A USB-to-UART converter (3.3V logic level—do not use 5V).
3. Target Wiring: Connect GND to GND, TX of converter to RX of CCxxxx, RX of converter to TX of CCxxxx. For CC2530/CC2540, also connect the RESET_N pin to a GPIO on your converter (for entry into bootloader mode).

Flash Operations:

Allows users to read, mass erase, write, and program flash memory. Software: Download SmartRF Studio 7 from TI’s website