Rk3128 Mxq Ep 68 Firmware [new] Guide

RK3128 MXQ EP 68 a specific motherboard revision found in budget Android TV boxes, most commonly the MXQ Pro 4K MXQ Pro 5G

  • Rockchip Driver Assistant: DriverAssitant_v4.5.zip
  • AndroidTool (RK Batch Tool): RK_Android_Tool_v2.81 or newer.
  • RK3128 Firmware file (.img extension)

Key Features

3. Required Tools & Software

  1. Open the case to access the PCB.
  2. Locate the NAND pins (usually tiny metal legs on a black chip labeled Toshiba or Hynix).
  3. Look for “TP” (Test Point) holes or a metal pad labeled CLK or CMD.
  4. Short the pins: Using tweezers, connect pin 7 and 8 of the NAND chip (or the two TP pads).
  5. While shorting: Plug the male-to-male USB cable into the USB port closest to the Ethernet jack (Port 1). Plug the other end into your PC.
  6. Release the short after 3 seconds.

Frequently Asked Questions

  1. The PCB Number: Open the box. Look at the green circuit board. Find a printed number like MXQ-EP-68-V2.1, V3.0, or V4.2. This is critical.
  2. The WiFi Chip: Look at the small silver rectangular chip near the antenna wire. If it says XR819, you need XR819 drivers. If it says 8188, you need Realtek drivers.
  3. The RAM Size: 1GB vs 2GB firmware is rarely cross-compatible.