Tanix Tx3 Mini Firmware -

This guide outlines how to refresh or unbrick your Tanix TX3 Mini (S905W/S905W2) using the official Amlogic USB Burning Tool. Pre-Update Checklist Before you begin, ensure you have the following: Correct Firmware: Verify your hardware revision (e.g., vs. Rockchip RK3228A models) . Using the wrong image can brick the device. USB A-to-A Cable:

• Insert the paperclip into the AV port. You will feel a button click inside.
• Hold the button down.
• While holding, plug the power cord into the TX3 Mini.
• Your PC should make the "Device Connected" sound (Ding!).

Introduction

B. FreakTab Forum (Highly Recommended)

1. Install USB Burning Tool + license (run as admin).
2. Open tool → File → Import image (choose .img).
3. Short the two pins on the NAND (or press reset button inside AV port).
4. Connect USB cable to PC → box powers on → “Connected” appears.
5. Click Start → wait for 100% → Stop → unplug.

3. CoreELEC (LibreELEC fork for Amlogic)

C. XDA Developers